First, the misplacement in the sculpture
1. Is the speed too fast? Is the parameter set correctly?
2. Is there any static electricity or external interference? Is there a ground wire?
3, check whether the machine shaft is lubricated
Second, the boot does not respond, the machine tool is dead, the handle does not respond, does not display
1. Reinstall the software in the position of the Weihong card slot in the computer case.
2. Is there a pin phenomenon in the data connection line of the DSP controller?
3. Check the power output current in the control box. Is the line on the terminal block correct? Is the aviation plug connected correctly?
4 drive total electric switch fuse tube rectifier is damaged
4, X Y Z motor seat on each axis. Silk female seat When the bearing seat is moving, whether there is any card in the same way.
5. The drive current is too small and the motor or drive is damaged.
Third, the square is not square, the circle is not round, there is a sawtooth
1. Adjust the bearing housing of each axis of the engraving machine. Silk female seat The three-point concentricity tightness of the motor base.
2. Adjust the parallelism of the machine and check whether the slider, motor belt, coupling, loose or damaged
Fourth, the vacuum pump does not turn without suction or reverse
1. Is the motor line voltage normal?
2. Whether the water circulation pump is less water, whether the motor is stuck or not, the motor fan protection net rotation axis is removed.
3, the countertop or the pipeline has air leakage phenomenon trimming
4, the vacuum pump inside the filter block cleaning
5. Forward and reverse the U V W on the motor. Any two wires change the direction of the motor.
5. The carvings are getting deeper or deeper and the machine tools are moving. The carving samples are different in depth.
1. Is the plate used for leveling flat?
2. Is there any gap in each axis?
3, too much interference plus filter magnetic ring to prevent interference
Sixth, the machine does not return to zero. After the completion of machining, it does not return to the working origin.
1. Is the Weihong card damaged?
2. Whether the limit switch is connected or not, whether the limit switch is damaged
3. Is the parameter in the DSP controller correct?
4, check the draft file problem
5. After the sculpture is finished, Weihong presses the F7 key and the DSP confirms whether it can return to the origin.
Seven, the size of the sculpture has an error
1. The pulse equivalent setting does not modify the parameters correctly.
2 compact the engraving material to prevent loosening
3, the screw seat coupling has gap adjustment
4, there is a problem in the file design conversion
Eight, the spindle does not reach the specified speed
1. Check if the circuit on the inverter and the terminal block is correct.
2, Weihong card data line terminal board damage DSP handle parameters are incorrect Reset
3. Re-adjust the internal parameters of the inverter
Nine, running in one direction or both
1, Weihong card damage
2, the data line is loose
3, Weihong or handle terminal block is damaged
4. The drive circuit is loose or the wiring is incorrect.
